Linux install how to do it?

t11s
I'd like to install Linux on my FriendlyARM Mini2440 + 3.5 inch LCD  + 1GB.

I obtained the file "linux_download.pdf".

I appear to have properly set up by serial connection and USB driver.  In
dnw.exe, I see the "FriendlyARM BIOS" menu, and the USB says it is
connected.

First, when I hit "x", I just get another menu, I don't see the "doing
partition" bit.  [At this point I appear to have wiped the Qtopia it came
with...]

Second, the document "linux_download.pdf" says "Set the USB Port download
address to 0x30000000.   Your PC screen will now be as below:" but the
picture below shows the download address as 0xC300000.  Which address is
correct?

Third, the document 'linux_download.pdf" says to hit "v" and then "Select
the “supervivi_mini2440” file".  Where can I get the file
"supervivi_mini2440" from???

Fourthly, the document 'linux_download.pdf" says to hit "k" and "Select the
“zImage_a35” if you have a 3.5” LCD".  Where can I get the file
"zImage_a35" from???

Finally, any idea what the default IP address of the system will be after a
successful Linux install?

Thanks!!!!!!!

-Thomas
  http://www.t11s.com

david
look on downloads there you can find all packages you are going to need
there is also a good tutorial of how to install linux step by step

davef
1.  you should see a few lines showing the parition table (if I recall
correctly)
2. 0x3000000
3. DVD or the downloads page
4. you sure?  n35 is for the 3.5" NEC
5. 192.168.1.230 is the factory default after installing Qtopia